已經改 D2PRO 的玩家可以帶主機過來升級晶片，升級後修正有時候光碟片會無法退片的問題，讓主機玩遊戲更順暢。 >>最新2.3下載 升級方法有兩種，一種是用d2prog更新，另一種是下載更新光碟更新。 一、d2prog更新 WINDOWS XP 版升級程式
>>download
>>download(2.1ALT)(須用d2prog來更新)驅動程式下載(勿用windows本身的自動搜尋驅動程式功能) 說明書下載 二、光碟片更新 設定光碟 1.5 版下載 日版 美版 歐版 ============================
d2pro v2.0 (final) - 9 wires
============================
This software is provided as-is, with no warranties of any kind.
If you use this software, you do so at your own risk!
Thank you for using d2pro!
================
Features / Fixes
================
- Works with DMS, D2A, D2B, D2C and D2C-2 chipset drives
- Adds D2C-2 compatibility to previous d2pro chips that have an SPI Flash
- Enables DVD update of the SPI Flash
- Updatable and configurable via utility disc
- Recovery Mode - can fully recover from a bad flash
- Region Fallback - impossible to brick the drive by setting the wrong region
- Fixes eject issues discovered in previous firmware versions
* This firmware does NOT support the newly-discovered d2e chipsets *
============
Instructions
============
1. If the d2pro chip is already installed in a Wii console then
disconnect the power cable.
2. Disconnect d2prog from the USB cable.
3. Connect the flat flexible cable to d2prog (and to d2pro if you have
not done so already).
Be VERY CAREFUL when connecting the cable and make sure that is in
place properly. If the cable is misaligned and the Vcc (power) and
ground lines are shorted d2pro or d2prog could be damaged.
4. Connect the USB cable to d2prog.
5. Run the updater software. It can be run without parameters for
fully interactive mode, or with the following switches:
usage: ./d2prog [-v] [-n] [-y] [-f ]
-v verify only
-n flash only, don't verify
-y start flashing immediately
-f select firmware
Run without parameters for fully interactive mode.
-h brings up the help.
6. Disconnect USB cable and then d2prog. (done!)
|
